Click here to Download PDF file.
DA 409U/S2-glass is a tough, versatile, modified epoxy resin
DA 409U/S2-glass is a tough, versatile, modified epoxy resin prepreg that cures at 250ºF. The S-2 glass is a Zentron High Strength fiber. Standard weight is 260g/m2 with a 38% resin content. Other weights and resin contents available upon request.
PHYSICAL PROPERTIES:
Uncured
Weight: .083lbs./sq ft
Thickness: ..011
Resin Content: 42% by Weight
Volatiles: Less than 1%
Gel Time: 12 min@250ºF
Shelf Life: One year at 0ºF
Six months at 40ºF
Twenty days at 75ºF
Standard Roll: 12 inches wide by 120 yds. long
MECHANICAL PROPERTIES:
Cure Cycle: Press cured for one hour at 250ºF and 50 psi pressure
Thickness:
Resin Content : 38% by weight
Flexural Strength: (ASTM D 790) @75ºF 112 KSI
Flexural Modulus: @75ºF 4.1 MSI
Tensile Strength: (ASTM D 3039) @75ºF 181 KSI
STORAGE:
Store material in a contaminate free container and store a 0ºF for extended storage. For shorter storage time requirements store at 40ºF, this enables quicker stabilization and less condensation build up on material.
APPLICATION:
Remove material from cold storage at least 20 hours prior to use to allow for stabilization at room temperature. Keep material wrapped to prevent moisture form condensing on the prepreg.
CLEAN UP:
The uncured adhesive can be removed from no-bonding areas with ketones or methylene chloride. Be sure to follow all Material Safety Data Sheet (MSDS) guidelines for the solvent to be used.
CAUTION:
This material contains epoxy resins and amines which may cause irritation to sensitive skin. Avoid con-tact with eyes or skin. If contact with skin occurs, wash as soon as possible with soap and water. If con-tact with eyes occurs, flush with water for 15 minutes. Do not handle or use this material until Material Safety Data Sheet has been read and understood. The user of this material is required to use the necessary protective equipment as directed by applicable state and federal laws when handling, curing, and grinding this material.
IMPORTANT NOTICE:
Information in this data sheet has been obtained under controlled laboratory conditions and is believed to be accurate. Properties listed are typical values and are not intended for use in preparing specifications. Actual values may vary. No warranty is expressed or implied for which APCM assumes legal responsibility. APCM cannot be responsible for misapplication or handling and use under conditions beyond its control and under no circumstances shall be liable for incidental or consequential damage resulting from handling or use of this material.
Click here to Download PDF file.